Water softeners for hard water
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
By OpenStats · Built from official Canadian sources
Regional estimateWater quality grade
Good
Graded against Health Canada drinking water guidelines
From source to sink
Lakes, rivers, wells, and treatment plants behind the kitchen tap, in plain language. Chemistry grades above are a separate lab snapshot; this section is the route the water travels.
Open the full tap storyOn the map
Source waters and treatment plants pinned from published utility names. Open a pin below for the full OpenStreetMap view.
Municipal service area
Approximate pin near Val-d'Or (exact plant coordinates pending)
Map data © OpenStreetMap contributors. Pins are approximate for orientation, not legal survey points.
Surface water
Research confidence: medium
Usine de production d’eau potable de Val-d’Or
Municipal surface treatment plant on the local Abitibi lake/reservoir system.
City aqueduct serving Val-d’Or’s urban area.
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
Best for hardness ≥ 180 mg/L
Confirm mg/L before sizing a unit
As an Amazon Associate, OpenStats earns from qualifying purchases.
Municipal reports cover the plant. A Tap Score kit tests the water at a Val-d'Or tap for a broader contaminant panel.
Lab kit partner link. We may earn a commission when tracking is active.
Val-d'Or's most recent drinking water sample (2026-07-22) reports hardness of 249 mg/L, classified as very hard, and pH 7.7, drawn from a surface water source and treated at Val-d'Or Water Treatment Plant. Lead measured 0.1 μg/L and fluoride 0.5 mg/L.
Free chlorine measured 0.6 mg/L in this sample. No E. coli was detected in this sample.
Val-d'Or's hardness of 249 mg/L is above the Quebec average of 183 mg/L across 34 tracked municipalities, with a provincial average pH of 7.5.
These readings summarize a single compliance snapshot, not a certification of the water reaching your tap. Test your own water periodically, especially on a private well, and consider a softener if hardness is classified hard or very hard.
How to use this page: read the headline metrics first, then where the water comes from (map and tap story), then the parameter table and source footer.
All monitored parameters meet Health Canada guidelines.
Health parameters compliant; minor aesthetic factors such as hardness or pH near guideline edges.
Figure 1 · From source to sink
How drinking water reaches your tap
Quebec · 34 cities in sample
Provincial average: hardness 183 mg/L · pH 7.5 · lead 0.3 μg/L · fluoride 0.6 mg/L
| Parameter | Reading | Health Canada guideline | Status |
|---|---|---|---|
| Hardness | 249 mg/L | No health limit (aesthetic) | Compliant |
| pH | 7.7 | 6.5–8.5 | Compliant |
| Lead | 0.1 μg/L | ≤ 5 μg/L | Compliant |
| Fluoride | 0.5 mg/L | ≤ 1.5 mg/L | Compliant |
| Chlorine (free) | 0.6 mg/L | ≤ 4 mg/L | Compliant |
| Turbidity | 1 NTU | ≤ 1 NTU (typical target) | Compliant |
On a private well or holding an Alberta water allocation licence? Water Register maps EPA licence records, transfer comparables, and watershed context across the province.
Explore WaterRegister.ca →Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
As an Amazon Associate, OpenStats earns from qualifying purchases.
· Compare options